OE Ref.:
43130-54J22
Commercial Name:
Schrader Clamp-in Gen 2 Suzuki 315MHz Renault SEL ASK
OEM Sensor P/N:
43130-54J22
Ean Code:
EZ-sensor® coverage:
YES
Nut Torque:
80 in-lbs (9 Nm) Nm
Screw Torque:
-- Nm
Valve Core Torque:
3.5 in-lbs (0.4 Nm) Nm
Note:
WARNING: This product contains chemicals including lead, which is known to the State of California to cause cancer and reproductive issues.
For more information, go to
www.P65Warnings.ca.gov.
EZ-sensor® GO is pre-programmed for all vehicles mentioned in the list. No programming is required before installation for the below applications. Additionally, the sensor can be programmed to 99% of all vehicle makes, models and years.
Click on item for more details:
This list is being continuously updated.
Part No.:
1086
20009
20009
Commercial Name:
TPMS Service Pack
Note:
Contents: 1 Aluminum Nut, 1 Plastic Sealing Cap, 1 Rubber Grommet, 1 Nickel Plated Valve Core
EZ-sensor® GO can be programmed to any Make Model and Year shown in this list.
Click on item for more details:
This list is being continuously updated.
Relearn Summary: Stationary Relearn
Relearn Description1. Inflate all tires to pressure indicated on tire placard.
2. Turn ignition to ON/RUN position (engine off).
3. Press and hold driver’s side door switch for 2 seconds. Release, then press again for 2 seconds. Release, then press again for 5 seconds.
4. SHUT THE DRIVER’S DOOR.
5. Place learn tool over LF tire and press activate/test button, then proceed to RF, RR, and LR. Sensors must be activated within 90 seconds.
6. When each sensor ID has been received by control module, TPMS telltale will be displayed for 5 seconds. TIA troubleshooting tip: Vehicle gives no indication it has entered learn mode, nor will it give any indication of accepting each sensor with a horn chirp. It is important to note that the technician must be VERY deliberate with timing when holding the switch down and releasing, and then close the driver’s door. Successful completion of a relearn procedure can be verified by turning ignition to “On” position and not seeing a MIL. See picture of door switch to the right:
Relearn Procedure as PDF document
Mounting Instructions
Note:
Sensor images shown in this document are for illustration purpose only!
Phisical sensor body may be different.
Non contractual document!
For tecnical information, please contact your supplier or leave a message at info@Schrader TPMS E-Catalog.com
User Manual/Quick Start Guide
Note:
Document contains full description user manual and / or Quick Start Guide. Non contractual document!
For technical information, please contact your supplier or leave a message at SchraderNA@sensata.com
Approvals and Declarations
Note:
Package contains FCC, IC and CE certifications
Physical sensor body may be different.
Other documents can be also found
here.